Graco Commercial How to install your Graco® SlimFit3™ LX 3-in-1 Car Seat Spot

VIDEO Graco How to install your Graco® SlimFit3™ LX 3-in-1 Car Seat TV commercial 2024 • How to install your Graco® SlimFit3™ LX 3-in-1 Car Seat FT ARB rear facing using UAS "Learn how to install your Graco® SlimFit3™ LX 3-in-1 Car Seat featuring Anti-rebound bar rear-facing using UAS with these simple steps. Want to learn more about the Graco® Slimfit3 LX 3-in-1 Car Seat featuring Anti-rebound bar car seat? Visit us: https://www.gracobaby.com/car-seats/t... #Gracobaby #graco #carseat 0:00 [Music] 0:04 hi I'm Sarah from Graco I'm going to 0:06 show you how to install your slimfit 3lx 0:10 3in1 car seat featuring anti-rebound bar 0:13 in rear facing mode using 0:17 uas to get started attach the 0:20 anti-rebound bar at the front of the car 0:22 seat this must be used in rear facing 0:26 mode next store the tether and remove 0:29 the uas connectors from their storage 0:31 location to do this lift the seat pad 0:34 and push down on the black tab in front 0:36 of the connector to remove it repeat on 0:39 the other 0:44 side then route the uas connectors 0:47 through the rear facing belt path marked 0:49 with a blue label if the Buckle is in 0:52 the middle or innermost position then 0:53 route the belt in front of it if the 0:55 Buckle is in the front position then 0:57 route the belt behind it make sure the 0:59 strap lies flat and is not Twisted in 1:01 the belt path use the front recline 1:04 handle to adjust the recline to 1:05 positions one or two as marked on the 1:07 blue label make sure it clicks into 1:11 place place the car seat rear facing in 1:13 your vehicle make sure the base of the 1:16 car seat is flat on the vehicle seat and 1:18 at least 80% of the base is on the 1:21 vehicle seat now check the level 1:23 indicator to ensure the ball is 1:25 completely within the Blue Zone if it's 1:27 not adjust the recline next extend the 1:31 uas strap by pressing on the gray button 1:34 and pulling on the 1:35 webbing now you can attach the uas 1:38 connector to the anchors in your vehicle 1:40 on each 1:42 side next pull the strap to tighten push 1:46 firmly in the center of the seat and 1:48 pull on the strap you can also pull the 1:50 free end of the strap through the belt 1:52 path to help tighten if 1:55 needed test for tightness place your 1:58 hands at the rear facing belt pad and 2:00 move the seat side to side and front to 2:02 back it should not move more than 1 in 2:05 finally reattach the seat pad and 2:08 recheck the level indicator to ensure 2:10 it's still completely in the Blue Zone 2:12 your car seat is now installed

---

---

Some articules for you